To allow STM32CubeProgrammer to access the USB port through low-level commands, proceed as follows: This is achieved by typing the following command from the host PC terminal: The libusb1.0 package (including USB DFU mode) must be installed to be able to connect to the board via the USB port. For Linux host PC or Windows host PC with VMWare:.It is recommended to use the USB (in DFU mode) for flashing rather than the UART, which is too slow.īelow indications on how to install the USB in DFU mode, for Linux and Windows OS, respectively. Ģ.2 Preparing the USB serial link for flashing Details about the content of this tool version are available from ST web site at Release Note.Instructions to follow for using the STM32CubeProgrammer can be found in user manual, UM2237 available from ST web site, or in STM32CubeProgrammer#How to flash with STM32CubeProgrammer article.Execute the Windows installer, which guides you through the installation process.$> ln -s /bin/STM32_Programmer_CLI /home/bin/STM32_Programmer_CLI For example, if "/home/bin" is in the PATH environment variable, run the following command: or once for all by creating a link to the STM32CubeProgrammer binary in a directory already present in PATH.either in each Terminal program in which the STM32CubeProgrammer binary needs to be used, using the following command:.The path to the STM32CubeProgrammer binary must be added to the PATH environment variable.Execute the Linux installer, which guides you through the installation process.Uncompress the archive file to get the STM32CubeProgrammer installers:.Download the archive file on your host PC in a temporary directory.Go on st.com to download the STM32CubeProgrammer software.STM32CubeProgrammer for Windows ® host PC STM32MP15 Flash mapping.Ģ STM32CubeProgrammer installation 2.1 Installing the STM32CubeProgrammer tool More details on supported Flash memory technologies and mapping can be found in Flash mapping articles, e.g. For example, for the STM32MP157 Evaluation board:ĭuring development, it is recommended to use a microSD card you can then switch to eMMC or NAND Flash memory. The connection between the host PC and the board can be done through UART or USB serial links.Īny Flash device supported on STM32MPU boards can be flashed using STM32CubeProgrammer. Once created, STM32CubeProgrammer allows populating and updating the partitions with the prebuilt binaries. STM32CubeProgrammer is the official STMicroelectronics tool for creating partitions into any Flash device available on STM32 platforms. 5.7 How to populate a microSD card inserted in a Linux host PC.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |